Installs the foundation (also to be allowed not to install), turns on

lathe

Installs the top die, pays attention to the good picture red line to

have to the position

Installs the stamping die (attention, top die must upward raise,

stamping die inserts from left to right)

Installs left is admitting the positioning pin again

About moves the stamping die

If on the chart way carries on the hydrostatic testing!

Attention: When suppresses the left stamping die, top die condition

(on drawing red line part)

Attention: When suppresses the right stamping die, top die condition

(on drawing red line part)

Adjusts the appropriate position the cutter, to the chart which prints

cuts the circle

Admits according to this in the left stamping die, the iron sheet, the paper, the membrane (acts according to paper thickness, flimsy puts two membranes, after thick printing paper, picture paper put a

membrane) to put smoothly starts to suppress!